|
Send us a realistic representative sample of the waste water your
KASELCO unit would be treating. We'll run it in a scale model of
our full-size units. This benchtop model is an accurate
representation of the treatment effectiveness of our commercial units.
In fact, we base our performance guarantees on it.
Treatment Targets:
Our lab is equipped to test for most metals using our Atomic Absorption
(AA) unit, and is equipped with analytical devices to test pH, conductivity,
total phosphorous, and turbidity (FAU). Be specific about the target pollutants and
provide your permit limits. We do not run the full library - this
isn't an EPA lab report - it's a treatability study - we'll run the
primary targets for you - before and after.
To support the design of solids
separation components, we filter the solids produced and weigh them to estimate sludge
production, and we time the settling rate for clarifier sizing estimate.
Please download our
Application Information Form, complete it and submit it PRIOR to sending the
sample. Let's be in communication so you can be sure you are
creating a real representative sample of what will be treated. If you
think there is a wide range, maybe two samples are necessary.
 Evaluation
Fee: US$200.00. If COD, BOD, TDS, TSS and/or O&G are required
(or unusual metals for which we don't have the standard), we use an
outside lab. Those charges - approximately $45 for each analysis - are
added directly to your invoice. We only charge a prospective customer
the Evaluation Fee once for
a given waste stream. If we need another 5 gallons or alter the waste and need a different
5 gallons, we don't charge again. |
|
Send a sample only after we have reviewed your
AIF and approved the receipt of the sample.
Send: 5 Gallons of raw, un-altered
sample - no pretreatment (this does not include any pretreatment for Cyanide
destruction - if there is any CN you must state so).
  Container:
5 gallon polyethylene bottle with 2" closure. These are the best -- Mark directly on it with magic
marker the source company and address, sample source, date of sample, and our
address.
How: Overnight is best.
Overnight is mandatory if BOD is the concern (and chilled is even better).
Packaging: The
transportation company may want this to be placed in a carton.
Label: "Non-regulated water sample
for analysis" (unless it isn't - if it contains a highly concentrated
hazardous pollutant that exceeds DOT RQ we probably can't treat it anyway).
Send To:
KASELCO
Lab
959 Highway 95 North
Shiner, TX 77984
Attn:
Jamie Bazan
Phone:
361/594-3327 x 305
.
|
Electrocoagulation
Wastewater Treatment Technologies, and More.
